Page 7 of 33
F2 User Manual Rev. 1
Setup
3. Setup
AC Power
The F2 has an auto-ranging power supply and it can work with an input voltage range of 100 to 240 VAC,
50/60 Hz.
To determine the product’s power requirements (circuit breaker, power outlet, and wiring), use the current
value listed on the label affixed to the product’s back panel, or refer to the product’s specifications chart.
The listed current rating indicates the product’s average current draw under normal conditions.
AC Plug
The F2 comes with a power input cord terminated with a Seetronic Powerkon A connector on one end and
an Edison plug on the other end (U.S. market). If the power input cord that came with your product has no
plug, or if you need the change the plug, use the table below to wire the new plug.
Power Linking
All F2 panels support power linking. Refer to the following table for specifications on each panel.
•
Always connect the product to a protected circuit (a circuit breaker or fuse). Make sure
the product has an appropriate electrical ground to avoid the risk of electrocution or
fire.
•
To eliminate unnecessary wear and improve its lifespan, during periods of non-use
completely disconnect the product from power via breaker or by unplugging it.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if the
rheostat or dimmer channel serves only as a 0 to 100% switch.
Connection
Wire (U.S.)
Wire (Europe)
Screw Color
AC Live
Black
Brown
Yellow or Brass
AC Neutral
White
Blue
Silver
AC Ground
Green/Yellow
Green/Yellow
Green
Voltage
F2 Products
@ 120 V, 60 Hz
7
@ 208 V, 60 Hz
13
@ 230 V, 50 Hz
13
Please refer to all applicable local codes and regulations for the proper installation of this
product.
Power
Source
1
st
Product
2
nd
Product
Additional Products
3
rd
Product
Summary of Contents for F2
Page 1: ...User Manual ...