FLOOR SUPPORTED CUBE-IT
Page 5 of 5
Installation Instructions
Grounding Wire
1. Use M5.5 self-tapping Torx screws, star washers, and grounding wire to
electrically bond center chassis to rear panel using any accessory holes.
Cable Access
1. Per cabling requirements removable cable knockouts are provided on top and
bottom of rear panel. Knockouts are removed using a large flat-head screw driver.
2. Use provided rubber grommets on large knockouts. Alternatively, large knockouts
will accommodate 2-1/2” metal conduit. Small knockouts accommodate ¾” metal
conduit.
Equipment Rail Adjustment
1. Loosen M8 bolts, star washers, and hex nuts to move equipment rails to
desired depth spacing.
2. Tighten M8 bolts, star washers, and hex nuts to secure equipment rails.
Ground Jumper Wire
(P/N 40159-009 sold separately)
1. Remove paint mask from grounding emboss with two holes.
2. Install ground jumper wire using two black M6 Torx TAPTITE screws.
3. Place grounding label next to ground emboss.
Cable Fill
Rubber Grommet
3in Knockout
1in Knockout
Grounding Emboss
Black M6 Torx Screw
Ground Jumper Wire
Grounding Label
M8 Carriage Bolt
Star Washer
M8 Hex Nut