FLOOR SUPPORTED CUBE-IT
Page 2 of 5
Installation Instructions
Removing from Pallet
1. Remove carton top and four corner protectors from cabinet.
2. The wheel kit and plinth ship packaged inside the cabinet. Remove both
boxes to install assemblies to cabinet.
3. Remove the six screws and washers that mount the cabinet to the pallet.
4. Move the cabinet off the pallet to the floor. CAUTION: USE TWO
PEOPLE TO REMOVE CABINET FROM PALLET TO PREVENT
TIPPING OVER.
5. To keep standard door swing, proceed to
Plinth and Caster Kit
Installation
instructions. To change door swing, follow
Reverse Door
Swing
instructions.
Reverse Door Swing (OPTIONAL)
1. Remove top access panel on rear panel by removing four hex nuts.
2. Remove the four plastic plugs from top of the center chassis.
3. Rotate entire cabinet so hinges are on opposite side.
4. Reinstall top access panel and plastic plugs.
5. Remove and reinstall door latch so that it is in correct orientation.
6. Remove and reinstall latch cam 180 degrees from default orientation.
7. Relocate CPI logo above swing handle.
Screw
Washer
Top Rear
Access Panel
Top Plugs
Door Latch
Logo
Swing
Handle