TERAFRAME
®
FRONT DOOR TWO-POINT ELS1000/ELS1500 LOCK
IIS-739229, 11/27/13, Rev. 1, CPI/
800-834-4969 (USA & Canada) • www.chatsworth.com • [email protected]
For international phone numbers, see our website or contact CPI Tech Support.
This drawing contains proprietary and confidential information and is protected by U.S. and international law. Unauthorized reproduction, disclosure or use of the drawing
or the information therein is expressly forbidden except as agreed to in writing by Chatsworth Products, Inc.
Page 1 of 6
Installation Instructions
Included Hardware:
ELS1000 Master kit:
M4X10mm Taptite screw 2 ea.
M4 Tooth Washer 2 ea.
M4 Washer, 1 ea.
M4 X 12mm screw 1 ea.
M6 X 11mm Clevis Pin, 2 ea.
6 mm E-ring Ext., 2 ea.
M10 Washer,1 ea.
ELS1000 latch box contains a set of standard fasteners, please select the items
below from the box:
M4 X 10mm Flanged Screw: 1 ea. M16 Nut: 1 ea.
ELS1500 Master Kit:
M4X10mm Taptite screw 2 ea.
M4 Tooth Washer 2 ea.
M10 washer, 1 ea.
M5 X 16mm screw, 2 ea.
M6 X 35mm Hex screw, 1 ea.
M6 X 11mm Clevis Pin, 2 ea.
6 mm E-ring Ext., 2 ea.
M10 washer, 1ea.
Please select the spindle below from the ELS1500 latch box:
Tools Required:
#2 Philips screw driver
19 mm Wrench
10 mm wrench
Rivet gun
ELS1000/1500 Lock Preparation:
Locate the batteries from the lock box and install in the latch before assembly.
Please refer to the following Instruction documents for configuring the locks:
IIS-739226 (ELS1000), ISS-739228 (ELS1500).
Installation Notes:
•
The cabinet door must be disassembled in order to install or remove a
two-point latch, because the lock rods extend beyond the top and
bottom of the door.
ELS1000 Lock Assembly Sequence:
1. Install the two point ELS1000 (Fig. 1) onto TeraFrame front door.
E-ring
Front plate 2
ELS1000
Front plate Border
ELS1000
ELS1000 lock
Rear plate
ELS1000
M4 X 10mm
taptite screw
Lock rod
M4 X 12mm
screw
M4 Tooth washer
Clevis pin
Cam
M16 nut
Fig. 1
ELS1000 Lock
M4 Washer
M4X10mm
Flanged screw
M10 Washer
0.787” (20 mm)
