23
(9)
Clear system log
(10)
System comp. set:
used to set component entire offset and angle compensation.
8.1. System set
Note:
in "system set", machine's value all set well by factory, usually don't need to change
the value in system set.
PIC8-2
(1)
Head up camera position calibrate:
this function is for adjusting the nozzle
and camera position, usually factory will set well, don't need to change it.
(2)
Nozzle position calibrate:
after set well the nozzle1 position, then set the
nozzle2,3,4. Aim at the center of the cross.
(3)
Vacuum detection set:
(4)
Use system stack offset:
if turn on this function, stack offset will be saved in
system, different work files all use one same offset. If turn off this function, stack
offset will be saved in work file (not system), different work files have different
offset information.
(Usually we suggest turn off this function)
(5)
TS calibrate (touch screen calibrate):
after calibration, the system will restart.
(6)
Backup/restore:
For load in and load out machine system parameters (factory
setting).
(7)
Save:
used to save all system setting. Note: if just changed the setting but not
