Charlton & Jenrick Infinity 780 BF, Owner'S Manual

Page: 24 / 36

24 LT6863 (ISS 05)
SECTION TEN Assemble the appliance (installation instructions)

Taking special care remove the ceramic liner set from
within the packaging. The rear liner is in two pieces. Place
the bottom rear liner upon the top edge to the air tray.
Angle the upper rear line into the fire box assembly and
place on top of the rear bottom line.

With the two rear liner in position. Offer the LH and RH
side liner into the bottom brackets within the burner
Shelf assembly. (Please note the patterned edge must be
positioned along the front). Push the top of the liner
back into the chamber sides and bend the finger fold
brackets to locate the side liners.

Fit the burner cover within the base of the burner tray.

Position the shapes components as described in section
four of this manual; it is important that
the shapes are positioned exactly as
described to ensure the correct operation
of the appliance. Badly positioned shapes
may result in the gas flame being driven
forward onto the glass and permanently
marking it.

The fireplace frame can now be fitted by
sliding the assembly over the 4mm
location studs positioned on the LH and
RH flange of the fire box. When positioned tighten all six
off fixings.

Taking great care, locate the glass panel within the gap between bottom
retaining bracket and glass seal.

When located push back against the seal and locate and tighten the three fixing
brackets. (Please note over tightening the fixing nuts can result in damage to the
glass panel) Glass is not covered by warranty.

Load 6 off of the 1.5 v “C” batteries into the holder provided and attach to
battery lead. Locate the loaded

Holder within the bracket at the bottom of the fireplace assembly.

Fit the Inlet cover at the bottom of the appliance between the glass panel and
fireplace frame assembly.

Finally Slide the LH and RH infill strip within the fireplace frame and the glass
panel.

When assembly is complete please refer to section three operation.
Burner cover assembly