14
14
JOGGING CTS KIT
JOGGING CTS KIT
3.0 Installation
Remove any other conversion kits from the
wheel wheel arm attachment bracket. Insert
the wheel arms by pressing the small button
and sliding the arm into the wheel arm
attachment bracket. The large button should
engage into the hole on the wheel arm
attachment bracket.
Slide the wheel axle all the way into the
wheel bracket dropouts.
With the quick release lever opened 90
o
to
the wheel brackets (ie. pointing straight
out), hand-tighten the nut on the back side
of the quick release skewer.
Install the quick release axle through the
wheel’s hollow axle with a spring on each
side of the wheel. Screw the nut onto the
other side of the skewer axle.
WHEEL ARM
WHEEL
BRACKET
QUICK RELEASE LEVER
Close the quick release lever by pushing it
flat against the wheel bracket. When the
nut is properly adjusted, you will feel resist-
ance halfway through tightening the lever.
Make sure the lever is closed towards the
back of the
carrier.
WARNING:
The following safety precautions should
be followed otherwise injury or death to
you or to your passengers could result:
– Use wrist safety straps at all times.
– Always use seat belts.
– Always use parking brake when
stroller is stationary.
– Never in-line skate with the jogging
kit.
– Never climb or descend stairs with the
jogging kit.
– Use extreme caution on hills.
WARNING:
Failure to properly attach wheels could
cause the wheels to fall off, resulting in
an accident and serious injury.
WARNING:
Overloading the carrier with more than
2.2lb (1kg) in the rear storage pouches
can make the carrier unstable.
