Basic Operation
Turning on and off the TV
• Turn on the TV
10
• Turn off the TV
Press the button on the remote control to enter standby mode.
Do not leave your set in standby mode for long periods of time. It is best to unplug the
set from the mains and aerial.
• No signal
There is No Signal menu on screen when there is no input signal. In TV/DTV mode, if
there is no signal in five minutes, the TV will turn off automatically. In PC-RGB mode,
the TV set will automatically turn off in 16 seconds if no input signal. When VGA cable
is connected, the TV turns on automatically.
Programme Selection
• Using the CH+/CH- on the panel of TV or on the remote control.
Press CH+ to increase channel number.
Press CH - to decrease channel number.
• Using 0- 9 digital buttons.
You can select the channel number by pressing 0 to 9. (In TV, DTV mode)
• Example
To select - channel (e.g. Channel 5): Press 5.
To select -- channel (e.g. Channel 20): Press 2 and 0 in a short time.
Volume adjustment
•
Press the
VOL+/-
button to adjust the volume.
•
If you want to switch the sound OFF, press the .
•
You can release mute by pressing the
or increase/decrease the volume.
Changing the Input Source
You can select the input source by pressing the
SOURCE
button on the remote control.
Press the
▲
/
▼
button to cycle through the input source, and press the
ENTER
button to
confirm your choice.
NOTE:
The picture is just for reference. Please operate with the OSD MENU of concrete TV
and refer to the AV terminal board.
button on remote control can turn on TV from standby mode.
Connect the AC input cable, at this time the
TV will enter standby mode.
Press the