Assembly
8
Rev
61302-20090428
Operation
Engine Location
Place the engine in a well-ventilated area.
DO NOT place the engine near vents or
intakes where exhaust fumes could be drawn
into occupied or confined spaces. Carefully
consider wind and air currents when
positioning engine.
Starting the Engine
1.
Make certain the engine is on a flat, level
surface.
2.
Rotate the fuel valve to the “ON”
position (to the left).
3.
Move the choke lever (Item A) to the
“Choke” position (to the left).
4.
ELECTRIC START: Turn the ignition
key to the “Start” position and hold until
engine starts. If the engine fails to start
within five seconds, release the key and
wait at least ten seconds before
attempting to start the engine again.
5.
RECOIL START: Pull the starter cord
slowly until resistance is felt and then
pull rapidly.
6.
As engine warms up, move the choke
lever to “Run” (to the right).
7.
Move the throttle lever (Item B) to the
“Fast” position.
NOTE
If the engine starts but does not run, make
certain that it is on a flat, level surface. The
engine is equipped with a low oil sensor that will
prevent the engine from running when the oil
level falls below a critical threshold.
Stopping the Engine
1.
Turn the ignition switch to the “Off”
position.
2.
Turn the fuel valve to the “Off” position.
Summary of Contents for 61302
Page 2: ......
Page 4: ......
Page 17: ...Specifications Rev 61302 20090428 13 Dimensions ...
Page 18: ...Specifications 14 Rev 61302 20090428 Parts Diagram ...
