Operation
12
Rev 46516-20100426 E
NOTE
Connecting a generator to your electric utility
company’s power lines or to another power
source may be against the law. In addition this
action, if done incorrectly, could damage your
generator and appliances and could cause
serious injury or even death to you or a utility
worker who may be working on nearby power
lines. If you plan to run a portable electric
generator during an outage, please notify your
electric utility company immediately and
remember to plug your appliances directly into
the generator. Do not plug the generator into
any electric outlet in your home. Doing so could
create a connection to the utility company power
lines. You are responsible for ensuring that your
generator’s electricity does not feed back into the
electric utility power lines.
If the generator will be connected to a building
electrical system, consult your local utility
company or a qualified electrician. Connections
must isolate generator power from utility power
and must comply with all applicable laws and
codes.
Stopping the Engine
1.
Turn off and unplug all electrical loads.
Never start or stop the generator with
electrical devices plugged in or turned
on.
2.
Let the generator run at no-load for
several minutes to stabilize internal
temperatures of the engine and
generator.
3.
Turn the ignition switch to the “Off”
position.
4.
Turn the fuel valve to the “Off” position.
Do Not Overload Generator
Capacity
Follow these simple steps to calculate the
running and starting watts necessary for
your purposes.
1.
Select the electrical devices you plan on
running at the same time.
2.
Total the running watts of these items.
This is the amount of power you need to
keep your items running.
3.
Identify the highest starting wattage of
all devices identified in step 1. Add this
number to the number calculated in step
2. Surge wattage is the extra burst of
power needed to start some electric
driven equipment. Following the steps
listed under “Power Management” will
guarantee that only one device will be
starting at a time.
Power Management
Use the following formula to convert voltage
and amperage to watts:
Volts x Amps = Watts
To prolong the life of your generator and
attached devices, follow these steps to add
electrical load:
1.
Start the generator with no electrical
load attached.
2.
Allow the engine to run for several
minutes to stabilize.
3.
Plug in and turn on the first item. It is
best to attach the item with the largest
load first.
4.
Allow the engine to stabilize.
5.
Plug in and turn on the next item.
6.
Allow the engine to stabilize.
7.
Repeat steps 5-6 for each additional
item.
NOTE
Never exceed the generator capacity when
adding loads.
Summary of Contents for 46516
Page 2: ......
Page 4: ......
Page 22: ...Specifications 18 Rev 46516 20100426 E Parts Diagram...
Page 25: ...Specifications Rev 46516 20100426 E 21 Wiring Diagram...
