100786 - 3500 PSI PRESSURE WAShER
ASSEMbLY
14
Attach the Trigger Gun Assembly
1. Attach the spray wand to the trigger gun.
2. Rotate (clockwise) the M22 coupler on the trigger gun until
the spray wand is secure. Do not overtighten.
3. Connect the end of the high pressure hose to the gun inlet
by sliding back the metal collar on the female connector on
the high pressure hose. Insert male fitting (on the trigger
gun) and release collar. Gently tug on hose to ensure proper
connection.
Connect the high Pressure hose
1. Completely uncoil and straighten the high pressure hose to
prevent kinks.
2. Align the male end of the high pressure hose to the quick
change connector on the high pressure pump.
3. Insert the high pressure hose connection into the pump quick
change fitting by sliding back the metal collar on the female
connector on the high pressure pump and fully insert male
fitting (on high pressure hose) and release collar.
4. Gently tug on hose to ensure proper connection.
5. Gently pull on the hose to be certain it is properly secured.
Connect the Garden hose
The water supply must come from a pressurized water spicket.
NEVER use hot water or water from pools, lakes, etc. Before
connecting the garden hose to the pressure washer:
1. Run water through the hose for 30 seconds to clean any
debris from the hose.
2. Inspect the screen and gasket in the water intake.
3. If the screen and gasket is damaged, do not use the machine
until the screen has been replaced.
4. If the screen is dirty, clean it before connecting the garden
hose to the machine.
To connect the garden hose to the machine:
1. Completely uncoil the garden hose or remove completely from
reel to prevent kinks.
NOTICE
There must be a minimum of 10 ft. (3 m) of unrestricted hose
between the pressure washer intake and the hose faucet or
shut off valve (such as a “Y” shut off connector).
2. With the hose faucet turned completely off, attach the end of
the garden hose to the water inlet. Tighten by hand.
Summary of Contents for 100782
Page 38: ......
