CHA LRT
Page 4
C.
RTU Cable -
The RTU Cable is a 20 ft. cable with 5.5 mm X 2.1 mm coaxial power plugs on each
end used to connect the RTU to the Motor Assembly.
D.
Aluminum Bracket -
The Aluminum Bracket is used to mount the Motor Assembly to the CHA
F-LOOP 3.0 Tuning Unit.
E.
Long Machine Screws -
The Long Machine Screws attach the Aluminum Bracket to mount the
CHA F-LOOP 3.0 Tuning Unit.
F.
Short Machine Screws -
The Short Machine Screws attach the Motor Assembly to the
Aluminum Bracket.
G.
Allen Wrench
–
The supplied Allen Wrench is used to tighten/loosen the shaft set screws.
Installation of the Loop Remote Tuner
Please use the following procedure to properly install the CHAR LRT to your CHA F-LOOP 3.0. Note that
the CHA LRT will only work with the CHA F-LOOP 3.0. In addition to the supplied components, shown in
plate (1), you will need a #2 Phillips Screwdriver.
1.
Place the CHA F-LOOP 3.0 Tuning Unit on a clean flat surface. Using the supplied Allen Wrench,
remove the Tuning Knob by loosening the shaft set screw, as shown in plate (2).
2.
Pull Tuning Knob off shaft, as shown in plate (2).
Plate 2. Tuning Knob Removal.