4
2
3
1
WHT
-2
RED
-1
5
6
6mm
1
2
4
WHT
RE D
1
4
LOCK
LIGHT
3
3
2
3
21
Multi-function Door Control: Press the white square to open or close the door. Press again to stop the door while it is
moving.
Light Feature: Press the Light button to turn the opener light on or off. If you turn it on and then activate the opener, the
light will remain on for 2-1/2 minutes. Press again to turn it off sooner. The Light button will not control the opener lights
when the door is in motion.
Lock Feature: Prevents operation of the door from portable remote controls. However, the door will open and close from
the Door Control push button, the Outside Keylock and the Keyless Entry Accessories.
•
To Activate: Press and hold the Lock button for 2 seconds. The push button light will flash as long as the Lock feature
is
on.
•
To turn off: Press and hold the Lock button again for 2 seconds. The push button light will stop flashing. The Lock feature
will also turn off whenever the “LEARN” button on the control panel is activated.
12
2
Install Door Control (optional)
Locate door control where the garage door is visible, away from door and door hardware and out of the reach of
children. Mount at least 1.5 m (5 feet) above the floor
Serious personal injury from a moving garage door may result from misuse of opener. Do not allow children to
operate the door control or remote control transmitter.
Permanently fasten the caution label permanently to the wall near the door control as a reminder of safe
operating procedures.
There are 2 terminals (1) on the back of the door control (2). Strip about 6mm (1/4") of insulation from bell wire (4).
Separate wires enough to connect the white/red wire to RED terminal screw 1 and the white wire to WHT terminal screw
2.
Fasten the door control to an inside garage wall with sheet metal screws (3) provided. Drill 4mm (5/32") holes and use
anchors (6) if installing into plasterboard wall. A convenient place is beside the service door and out of reach of children.
Run the bell wire up the wall and across the ceiling to the garage door opener. Use insulated staples (5) to secure wire.
The receiver quick connect terminals are located behind the light lens of the opener. Connect the bell wire to the terminals
as follows: white/red to red (1) and white to white (2).
Operation of the Door Control
Press to open or close the door. Press again to stop the door while moving.
