Chamberlain 893LM Quick Start Manual Download Page 1

Single Button Remote Control
Model 891LM

3-Button Remote Control
Model 893LM

TO ERASE ALL CODES FROM MEMORY

REMOTE CONTROLS 

MODELS 891LM & 893LM

To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:
•   ALWAYS keep remote controls out of reach of children. NEVER permit children to operate, 

or play with remote controls.

•   Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there are 

no obstructions to door travel.

•   ALWAYS keep gate or garage door in sight until completely closed. NEVER permit anyone to 

cross path of moving gate or door.

Press and hold the button 

on the remote control 

that you wish to use.

“click”

“click”

Release the button 

when the garage 

door opener lights 

blink 

or 

two clicks 

are heard. 

If programming to

other products, 

press the button a

second time to 

activate the product.

Locate the 

Learn button.

                           Press and 

                     immediately release 

                the Learn button. 

           The Learn LED will glow 

         steadily for 30 seconds.

             Within 30 seconds...

PROGRAM USING THE GARAGE DOOR OPENER

For use with S 2.0™ products. All S 2.0™ Garage Door Openers have a yellow Learn 

button and two yellow antennas. The code between the remote control and the receiver changes 

with each use, randomly accessing over a billion new codes. Refer to your product manual for the 

location of the learn button.
NOTE: Your product may look different than the products illustrated in this manual.

When deactivating any unwanted remote 

control code, all previous codes will be 

erased.

Press and hold the Learn button on garage door opener 

or other product until the learn LED goes out 

(approximately 6 seconds). All previous codes are 

now erased. Reprogram each remote control you 

wish to use.

LED

LED

Press the LEARN button again, 

the LED will flash once.

Press the LEARN button on 

the door control to enter

Programming Mode.

The command LED 

will flash once.

The command LED 

will flash once again.

Press and hold the button 

on the remote control 

that you wish to use.

“click”

“click”

Release the button when 

the garage door opener 

lights blink 

or 

two clicks 

are heard. 

If programming to other 

products, press the 

button a second time to 

activate the product.

PROGRAM USING THE DOOR CONTROL

For more information, please visit www.devancocanada.com or call toll free at 855-931-3334

Reviews: