To Control the Opener Lights
NOTE:
Not available with universal receiver.
With SECURITY
✚
®
transmitters, a remote push button can be
programmed to operate the opener lights without opening
the door.
1.
With the door closed,
press and hold the remote button that
you want to control the light.
2. Press and hold the Light button on the door control.
3. Press and hold the Lock button on the door control.
4. After the opener lights flash, release all buttons.
Test by pressing the remote push button. The opener lights
should turn on or off but the door should not move.
Model 41A6127 Three-Button Security
✚
®
315 MHz Control
OWNER’S MANUAL
Only for use with 315 MHz Security
✚
®
garage door openers
and universal receivers that have an orange “learn” button.
KG
1
3
9
7
5
KG
1
3
9
7
5
Instructions Are Described and Illustrated Below
1. Press and release the
“learn” button. The learn
indicator light will glow
steadily for 30 seconds.
2. Within 30 seconds, press and hold the
button on the hand-held remote.
3. Release the button when the light blinks.
It has learned the code.
To Erase All Codes From Motor
Unit Memory
To deactivate any unwanted remote, first erase all codes:
Press and hold the “learn” button until the
learn indicator light goes out (approximately
6 seconds). All previous codes are now
erased. Reprogram each remote or keyless
entry you wish to use.
To prevent possible SERIOUS INJURY or DEATH from a moving
gate or garage door:
• ALWAYS keep remote controls out of reach of children. NEVER
permit children to operate, or play with remote control
transmitters.
• Activate gate or door ONLY when it can be seen clearly, is properly
adjusted, and there are no obstructions to door travel.
• ALWAYS keep gate or garage door in sight until completely closed.
NEVER permit anyone to cross path of moving gate or door.
WARNING
CAUTION
WARNING
WARNING
© 2004, Chamberlain Group Inc.
114A3007
All Rights Reserved
Printed in Mexico
FOR SERVICE DIAL OUR TOLL FREE NUMBER:
1-800-528-9131
The Remote Control Batteries
The lithium batteries should produce
power for up to 5 years. To replace,
pry open case with visor clip or
screwdriver, as shown. Insert
batteries
positive side up (+).
Dispose of old batteries properly.
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
WARNING
CAUTION
WARNING
WARNING
®
NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of
this receiver and/or transmitter are prohibited, except for changing the code setting or replacing
the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
Ba
tt
er
y
p
o
sitiv
e
si
de
up (+)
