CG emotron TSA Series, Instruction Manual

Page: 37 / 204

CG Drives & Automation 01-5980-01r2 Application guidelines 33
4.3 The Application Functions List
This list gives an overview of many different applications
with their challenges and a possible solution within the
functions of the Emotron TSA.
Description and use of the table:
“Application”
This column gives the various applications. If the machine
or application is not found in this list, try to identify a
similar machine or application. If in doubt please contact
your supplier.
“Challenge”
This column describes possible challenges that are familiar
for this kind of application.
“Emotron TSA Solution”
This column gives the possible solution for the challenge
using one of the functions of the Emotron TSA.
“Menu/Chapter”
This column guides you to the menu, menu group, or
manual section where you find a description of the settings
for the function.
For instance "331=Sqr Torq Ctr", means: set menu [331] to
“Sqr Torq Ctr.”
Example: Hammer mill
• Linear torque control (menu [331], selection ”Lin Torq
Ctr”) will give the best results.
• Torque boost to overcome high breakaway torque (menu
[337], submenus [3371]and [3372]).
• Overload alarm function for jamming protection (menu
[410] “Load Monitor”, with submenus for maximum
alarm)
Stop function reverse current brake (set “Stop Method”
[341] to “Brake”, and menu [344] to “Rev Curr Brk”). It is
possible to set a “Reversed Current Braking Delay” in menu
[346].