3300IP VoIP Phone | User Manual
www.CetisGroup.com
11
In the example of
Memory 2
, (TS1107) will transfer
“silently” to extension 1107. ‘Silent’ means the user will
not hear the DTMF tones.
In
Memory 3
, the transfer to 1107 will occur, after the
connection is established, a pause will happen then
digits are sent. P=1-second pause, so PPP = 3
seconds, then the digits (12345) are sent.
3.5.9.2 Call Park and Retrieve
Call Park/Retrieve allows the phone’s user to send a
call to a ‘Park’ location (setup within the PBX), where
another user may then ‘Retrieve’ the call from a
different phone.
It is programmed as follows in two steps:
1. Under SIP Config => Advanced Set you will find Park
Mode. Default is Off, and Park 1 is enabled or On.
2. Under Advanced => Memory Key, program the
Memory Key HdActive
to Transfer Silent the call to the
Park Location (70 in the example below). Eg:TS70
Also program
Memory Key HdIdle
to Retrieve from the
Parked Location. In this case TS71. The Park and
Retrieve numbers (70 and 71) are arbitrary, and subject
to the programmer of the PBX. They are used her as an
example only.
3.5.10 MMI Filter
MMI filter is used to make access limit to 3300IP phone.
When MMI filter is enable. Only IP address within the
start IP and end IP can access 3300IP phone.
3.5.1 1 Audio Settings
CODEC:
select the prefer CODEC; support ulaw, alaw,
G729 and G7231 5.3/6.3
Signal Standard:
Signal standard for different area.
Handdown Time:
hand down detect time.
Input Volume:
Handset in volume.
Output Volume:
Handset out volume.
Handfree Volume:
Hand free volume
G729 Payload Length:
G729 payload length
VAD:
Enable/disable Voice Activity Detection
3.5.12 VPN
This page is VPN setting page, the IP phone support
the VPN with UDP and L2TP protocol .The parameters
is as below
VPN IP:
After VPN registered successfully, VPN server
will give an IP aggress to the terminal. If there is a IP
address shown on terminal (except for 0.0.0.0), it
means your VPN has registered UDP Tunnel
VPN Server Addr
: register to the address of VPN server
VPN Server Port:
register to the port of VPN server
Server Group ID:
the group ID of UDP VPN
