CET PFP-46hpVW-2D Instruction Manual Download Page 1

*

C

E

T

 i

a

 t

ra

d

e

m

a

rk

 o

C

E

T

 F

ir

e

 P

u

m

p

M

fg

 L

td

.

75 Hector St., P.O. Box 90, Pierreville (Québec) Canada  J0G 1J0      Telephone: 1-800-567-2719      Fax: 1-800-434-2613      

www.fire-pump.com

ACCEPT ONLY THE BEST

A   C E N T U R Y   O F   E N G I N E E R I N G   F O R   T H E   B R A V E S T

PFP-46hpVW-2D

INSTRUCTIONS  MANUAL

Congratulation, you have just purchased a C.E.T. portable pump.  If you follow the procedures in this
operation manual, it will give you years of use without any problems.

ENGINE SPECIFICATIONS

• Volkswagen 46hp at 3600 RPM, air cooled engine.
• 4-cylinder, 4-stroke gasoline engine.
• Two 3 gallons (11,4l) capacity remote fuel tank

PUMP UNIT SPECIFICATIONS

• C.E.T. is using the new technology of a dual stage centrifugal pump.
• Pump body made from resistant aluminum alloy.
• Bronze impellers.
• Mechanical shaft seal.
• Stainless steel pump shaft.
• Electric priming system, guaranteed up to 20’ (6 meter) lift.
• Two 2 1/2” (65 mm) delivery outlets.
• One 4” (100 mm) suction inlet.
• Dimensions : Length : 41 1/4” (1047 mm); Width : 31 5/8” (803 mm); Height : 31 1/2” (800 mm).
• Weight : 395 lbs (178kg).

CONTROL PANEL

• Engine start/stop button.
• Throttle control lever.
• Choke control lever.
• Oil control lamp.
• Operating panel light.
• Pressure gauge.
• Vacuum pressure gauge.

PERFORMANCE

625 GPM (2363 LPM)  @    50 PSI    (3.5 bar)
530 GPM (2003 LPM)  @   100 PSI   (6.9 bar)
275 GPM (1040 LPM)  @   150 PSI (10.3 bar)
190 GPM   (718 LPM)  @   175 PSI (12.1 bar)
100 GPM   (378 LPM)  @   200 PSI (13.8 bar)

Your pump comes with a full year warranty on all mechanical components.

Summary of Contents for PFP-46hpVW-2D

Page 1: ...UNIT SPECIFICATIONS C E T is using the new technology of a dual stage centrifugal pump Pump body made from resistant aluminum alloy Bronze impellers Mechanical shaft seal Stainless steel pump shaft Electric priming system guaranteed up to 20 6 meter lift Two 2 1 2 65 mm delivery outlets One 4 100 mm suction inlet Dimensions Length 41 1 4 1047 mm Width 31 5 8 803 mm Height 31 1 2 800 mm Weight 395 ...

Page 2: ... as possible Use your pump with less than 12 in of water below the inlet of the suction hose Allow your pump to run without surveillance Run the pump with the discharge valve closed for more than 1 minute STARTING PROCEDURE Place your pump on a hard stable surface within 15 from horizontal Check the oil Check the gas tank level Connect your suction hose Make sure that there is a rubber seal on the...

Page 3: ...age from suction hose If the engine seems to speed up and down lost of suction Make sure the suction hose is straight and does not allow any air pockets to be trapped Check any air leakage in the suction or mechanical seal between the pump casing and the engine Loss of suction head Check the rubber seal in the suction hose The pump is not pumping as much as it should and the revolutions of the eng...

Page 4: ... improperly maintained or for equipment which has been returned for inspection or repair more than ten 10 days after defect complained of has been or should have been discovered by the Purchaser or Equipment which is operated after the defect has been discovered 3 CET incurs no liability for alteration or repairs unless the Purchaser first receives CET written consent or approval CET will not be r...

Reviews: