17
18
Press the Di2 battery
into the Seatpost
Internal Battery Mount
(MT-BINT-SP2) and
attach the E-wires
according to manufacturer
instructions.
Insert the assembled
battery and holder into
the seatpost.
DI2 BATTERY INSTALLATION
The battery for your Shimano Di2 system mounts inside the
seat tube using the Seatpost Internal Battery Mount (MT-BINT-SP2).
As this is an enclosed location, it is important to test the system
prior to final installation.
SEATPOST ASSEMBLY & INSTALLATION
1. Apply a light coat of carbon assembly
compound to the upper face of the
Seatpost, making sure to cover area
around the adjustment slots.
2. Locate saddle rail between upper and
lower clamps, and place on Seatpost.
3. With alignment washers installed,
attach assembly to Seatpost, by
tightening lightly greased fixing
screws, alternating between the two
sides each 1/2 turn. Once saddle is
adjusted, tighten fixing screws to a
maximum of 8 Nm.
SP-SP24-15MM
Upper Clamps
Lower Clamp
Alignment
Washers &
Fixing Screws
SP-SP24-ZERO
The R5 uses a proprietary
shaped seatpost. Do not
attempt to use any seatpost
other than the model provided
by Cervélo.
Accessory Mount
Kit (Rear)
MT-LM-R-003
Replace rear upper
clamp with Accessory
Mount kit version.
Tighten to maximum
8Nm.
Torque fixing
screws to 2.5Nm.
