Installation Guide for FibeAir IP-20S, FibeAir IP-20S Assured
Page 93 of 105
Ceragon Proprietary and Confidential
7.1
Special Note on Converting ValuLine 3 Antennas
Part numbers for ValuLine 3 antenna conversion kits are valid for most ValuLine 3
antennas, integrated or non-integrated. These conversion kits can also be used to
convert Andrew ValuLine 3 antennas with the old Nera Evolution interface to RFU-
C. The kits support the majority of Andrew’s Va
luLine 3 antennas, 1-6ft. However,
since there are some unique cases in which Andrew provided special antennas
which are not supported by these adaptors, it is recommended that you supply
your Ceragon representative with a picture of the current antenna (back plain
side), in order to confirm the antenna’s compatibility prior to implementing this
solution.
You can also check the following to determine whether the antenna is compatible
with the conversion kit:
•
Verify that the antenna is, in fact, a ValuLine 3 antenna.
•
Verify that the back plate of the antenna has in its holding plate the six
mounting holes shown in red in the figure below.
