User Guide for FibeAir® IP-20 All-Outdoor Products, CeraOS 10.5
Page 706 of 825
Ceragon Proprietary and Confidential
22.6
Configuring Voltage Alarm Thresholds and Displaying Voltage
Threshold PMs (CLI)
You can configure undervoltage and overvoltage alarm thresholds.
The default thresholds for IP-20C are:
•
Undervoltage Raise Threshold: 32V
•
Undervoltage Clear Threshold: 34V
•
Overvoltage Raise Threshold: 60V
•
Overvoltage Clear Threshold: 58V
The default thresholds for the other IP-20 all-outdoor products are:
•
Undervoltage Raise Threshold: 36V
•
Undervoltage Clear Threshold: 38V
•
Overvoltage Raise Threshold: 60V
•
Overvoltage Clear Threshold: 58V
These thresholds determine when the following alarms are raised and cleared:
•
Alarm #32000: Under voltage
•
Alarm #32001: Over voltage
To display the current thresholds, enter the following command in root view.
root> platform management voltage thresholds show
To change the threshold for raising an undervoltage alarm, enter the following
command in root view:
root> platform management undervoltage set raise-threshold <0-100>
To change the threshold for clearing an undervoltage alarm, enter the following
command in root view:
root> platform management undervoltage set clear-threshold <0-100>
To change the threshold for raising an overvoltage alarm, enter the following
command in root view:
root> platform management overvoltage set raise-threshold <0-100>
To change the threshold for clearing an overvoltage alarm, enter the following
command in root view:
root> platform management overvoltage set clear-threshold <0-100>
You can display voltage PMs that indicate, per 15-minute and 24-hour periods:
•
The number of seconds the unit was in an undervoltage state during the
measured period.
•
The number of seconds the unit was in an overvoltage state during the
measured period.
•
The lowest voltage during the measured period.
•
The highest voltage during the measured period.
To display voltage PMs, enter the following command in root view:
root> platform management voltage pm show pm-interval-type
<all|15min|24hr>
