User Guide for FibeAir® IP-20 All-Outdoor Products, CeraOS 10.5
Page 464 of 825
Ceragon Proprietary and Confidential
13.14
Enabling ACM with Adaptive Transmit Power (CLI)
When planning ACM-based radio links, the radio planner attempts to apply the
lowest transmit power that will perform satisfactorily at the highest level of
modulation. During fade conditions requiring a modulation drop, most radio
systems cannot increase transmit power to compensate for the signal
degradation, resulting in a deeper reduction in capacity. The IP-20 is capable of
adjusting power on the fly, and optimizing the available capacity at every
modulation point.
To enable Adaptive TX Power for a radio, enter the following command in radio
view:
radio[x/x]>rf adaptive-power admin enable
To disable Adaptive TX Power for a radio, enter the following command in radio
view:
radio[x/x]>rf adaptive-power admin disable
To display whether Adaptive TX Power is enabled, enter the following command
in radio view:
radio[x/x]>rf adaptive-power show status
The output of this command is:
radio [x/x]>rf adaptive-power show status
RF adaptive power admin status: [enable/disable]
RF adaptive power operational status: [up/down]
RF adaptive power operational status:
Up
means the feature is enabled and
fully functional for that radio link. Note that the feature is configured and
operates independently for each radio link.
