User Guide for FibeAir® IP-20 All-Outdoor Products, CeraOS 10.5
Page 460 of 825
Ceragon Proprietary and Confidential
13.13
Configuring the Radio Parameters (CLI)
In order to establish a radio link, you must:
•
Enter radio view.
•
Verify that the radio is muted (the
Mute Status
should be
On
).
•
Configure the radio frequencies.
Note:
Even if you are using the default frequencies, it is mandatory to
actually configure the frequencies.
•
Configure the TX level.
•
Set
Mute Admin
to
Off
.
•
Verify that the radio is unmuted (the
Mute Status
should be
Off
).
13.13.1
Entering Radio View (CLI)
To view and configure radio parameters, you must first enter the radio’s view
level in the CLI.
To
enter a radio’s view level
, enter the following command in root view:
root> radio slot <slot> port <port>
Table 87: Entering Radio View CLI Parameters
Parameter
Input Type
Permitted Values
Description
slot
Number
2
port
Number
Radio Carrier 1: 1
Radio Carrier 2 (IP-20C
and IP-20C-HP only): 2
The specific radio carrier
you want to access.
The following command enters radio view for radio carrier 1:
root> radio slot 2 port 1
The following prompt appears:
radio[2/1]>
