Ceragon FibeAir IP-20 All-Outdoor Series, User Manual

Page: 268 / 825

User Guide for FibeAir® IP-20 All-Outdoor Products, CeraOS 10.5
Page 268 of 825
Ceragon Proprietary and Confidential
◦
To enable the selected services, in the Multiple Selection Operation
section underneath the Ethernet Services Configuration Table, select
Operational and click Apply .
◦
To disable the selected services, in the Multiple Selection Operation
section underneath the Ethernet Services Configuration Table, select
Reserved and click Apply .
◦
To delete the selected services, select Delete underneath the Ethernet
Services Configuration Table. Before deleting a service, you must delete
any service points attached to the service, as described in
Deleting a
Service Point .
Figure 198: Multiple Selection Operation Section (Ethernet Services)
Note: When setting multiple services to Reserve state, make sure to avoid
setting the management service to Reserve state.
6.1.8 Viewing Service Details
To view the full service parameters:
1 Select
Ethernet > Services . The Ethernet Services page opens ( Figure 196 ).
2 Select the service in the Ethernet Services Configuration table.
3 In the Ethernet Services page, click
Service Details . The Ethernet Services –
Service Details page opens. The Service Details page contains the same fields
as the Add page (
Figure 197 ). However, in the Service Details page, these
fields are read-only.