Ceragon FibeAir IP-20 All-Outdoor Series, User Manual

Page: 267 / 825

User Guide for FibeAir® IP-20 All-Outdoor Products, CeraOS 10.5
Page 267 of 825
Ceragon Proprietary and Confidential
Note: Additional configuration of the MAC address table can be performed
via the CLI. See
Defining the MAC Address Forwarding Table for a
Service .
9 In the Default CoS field, enter a default Class of Service (CoS) value (0-7). This
value is assigned to frames at the service level if CoS Mode is set to Default-
CoS. Otherwise, this value is not used, and frames retain whatever CoS value
they were assigned at the service point or logical interface level.
10 In the CoS Mode field, select one of the following options. This parameter
determines whether or not frames passing through the service have their CoS
modified at the service level. The CoS determines the priority queue to which
frames are assigned.
◦
Default CoS – Frames passing through the service are assigned the default
CoS defined above. This CoS value overrides whatever CoS may have been
assigned at the service point or interface level.
◦
Preserve-SP-COS-Decision – The CoS of frames passing through the service
is not modified by the service's default CoS.
11 Click Apply , then Close to close the Ethernet Services - Add page.
12 Add service points. You must add service points to the service in order for the
service to carry traffic. See Configuring Service Points .
6.1.5 Editing a Service
To edit a service:
1 Select
Ethernet > Services . The Ethernet Services page opens ( Figure 196 ).
2 Select the service in the Service Configuration Table.
3 In the Ethernet Services page, click
Edit . The Ethernet Services - Edit page
opens.
This page is identical to the Ethernet Services - Add page ( Figure 197 ). You can
edit any parameter that can be configured in the Add page, except the Service ID .
6.1.6 Deleting a Service
Before deleting a service, you must first delete any service points attached to the
service.
To delete a service:
1 Delete all service points attached to the service you wish to delete, as
described in Deleting a Service Point.
2 Select Ethernet > Services . The Ethernet Services page opens ( Figure 196 ).
3 Select the service in the Ethernet Service Configuration Table.
4 Click
Delete. The service is deleted.
6.1.7 Enabling, Disabling, or Deleting Multiple Services
To enable, disable, or delete multiple services:
1 Select
Ethernet > Services . The Ethernet Services page opens ( Figure 196 ).
2 Select the services in the Ethernet Services Configuration table, or select all
the services by selecting the check box in the top row.