Ceragon FibeAir IP-20 All-Outdoor Series, User Manual

Page: 165 / 825

User Guide for FibeAir® IP-20 All-Outdoor Products, CeraOS 10.5
Page 165 of 825
Ceragon Proprietary and Confidential
3.7.5 Viewing the Configuration of the Standby unit
You can view the settings of the standby unit any time.
To view the settings of the standby unit, click the Standby tab of the desired page.
The following is an example of the Standby tab of the Radio Parameters page
after Protection Admin has been enabled.
Figure 105: Standby Tab of Radio Parameters Page
3.7.6 Editing Standby Unit Settings
Almost all settings of the standby unit are view-only. However, several settings
are editable on the Standby unit. They must be configured separately for the
Standby unit, and are not copied via copy-to-mate, nor do they trigger a
configuration mismatch in the CLI.
In the Web EMS, failure to synchronize these configuration settings causes a
configuration mismatch alarm.
The following settings must be configured separately on the standby unit:
•
Setting the Unit Name – in the Name field of the Unit Parameters page (see
Configuring Unit Parameters ).
•
Disabling/enabling Radio TX-mute – in the TX mute field of the Edit Radio
Parameters window. Refer to Configuring the Radio Parameters .
• Clearing the Radio and RMON counters – in the TX mute field of the Counters
Page . Refer to Displaying and Clearing Defective Block Counters .
• Setting the activation key configuration – in the Activation Key and Demo
admin fields of the Activation Key Configuration Page (see Configuring the
Activation Key ).
• Defining user accounts – Refer to the Access Control User Accounts Page
(see Configuring Users ).
• Setting synchronization settings – Refer to the SyncE Regenerator
page (see Configuring SyncE Regenerator ).