STEP 5
STEP 5-6 Flybar, Paddles & Washout
Attach two Short Balls to the Washout
Mixing Arms ( Note, attach from the flat
side of the arm). Secure the semi-as-
sembled mixing arms onto the Washout
Hub using one slide tube inserted from the
flat side and secured using one 3x16mm
Socket Cap Screw and 3x7mm Flat Washer per
arm. Press the radius link on to the inner balls on
the Swashplate.
STEP 6
Semi-Assembled
Align each paddle 'A' to be parallel with the flybar
control arms 'B'. This is made very simple with the optional pitch and paddle gauge CN2026
M3x5SS Set Screw x 2
(small hex key)
M3x3SS Set Screw x 2
(small hex key)
Radius Link
& M2x12 Pin
[HI3152A]
M3x16 Socket
Cap Screw x 2
Flybar [HW3173]
* packed with
tailboom
Flybar Paddles
& Weights
[HI3179] x 2
Flybar Control Arm x 2
Steel Ball x 2
M2x10PH x 2
[HI3176]
From parts bag 1, slide and center the Flybar through the seesaw arm assembly. Install one
Steel ball onto each flybar control arm with one 2mm screw, slide the Spacer, Flybar Control Arm on the
flybar. Loosely tighten the control arms. Using a ruler, check the distance between the end of the flybar and
the control arm and adjust until the lengths are the same and there is no free play between the control arms
and the rotor head. Remove one set screw at a time, apply threadlock and tighten in place. Slide the Flybar
Weight (Tip: the flat end of the weight faces the paddle) and thread on the Flybar Paddle until all the threads
are covered onto the flybar and align the paddles parallel. Again using the ruler, rotate one paddle or the
other to get equal distances, remember leading edge of the paddles turn clockwise. Using two 3x3mm Set
Screws secure the weights using threadlock.
Swashplate
Assembly
[HI3146A]
M3x7 Flat
Washer x 2
Medium
Black Ball
x 2
Washout Hub Assembly
[HI3152B]
7
Spacer M3x6
[HI3167D]
Slide
Tube x 2
A
A
B
A=B=A
Leading Edge
Leading Edge
For balancing of
rotor head see Final
Adjustments
Clockwise
Rotation
Optional Head
Button
CN2215
Medium Black Ball x 3
Medium
Silver Ball
x 2
Short Silver
Ball x 2
Starting with the inside race, apply threadlock
and attach two short silver balls directly across
from each other, similarly attach two medium
silver balls to the remaining holes. Attach the
three medium black balls to the outside race.
The rear location is not used.
Oilite
bushing
