Centurion CP71, Installation Manual

Page: 6 / 40

ref. 1012034A.cdr
3.0 RECOMMENDED TOOLS
MASONRY BITS
16mm
SPANNER
1 x 10mm/2 x 13mm
1 x 17mm/1 x 19mm
SCREW DRIVER
3,5mm FLAT
No 1. PHILLIPS
CRIMPING TOOL
AND PIN LUGS
PLIERS/SIDE
CUTTER
HAMMER
TAPE MEASURE
ALLEN KEYS
3mm ACROSS FLATS
10mm ACROSS FLATS
HACKSAW
SOLDERING IRON PICK SPADE
ELECTRIC
DRILLING
MACHINE
4.0 TYPES OF BOOM
4.1 CENTRY PRE-TENSION SPRING
ARM LENGTH
There are two standard arm lengths available:
OPERATIONAL MODES
Two standard operational modes are available:
SIMPLEX (sometimes called Domestic) - Use BMDV1.X firmware
COMPLEX (sometimes called Commercial) - Use BMCV3.X firmware
The mode is determined by the microprocessor fitted to the CP88 control card as well as
selecting which loop detectors are required, (See next section)
3m
4.5m
6 6
L
3.0m Barrier L=80mm
4.5m Barrier L=20mm
CENTRY PRE-TENSION SPRING
Adjust according to boom
Pole Length
3.0m Pole: L=80mm
4.5m Pole: L=20mm