Centurion CP71, Installation Manual

Page: 18 / 40

18 18
7.5 BOOM ASSEMBLY
1
If the boom pole has not been
supplied pre-drilled, use the
external clamping piece as a
template, mark and drill the 10.5
mm holes in the boom pole. In
order for the end cap to fit
correctly, there must be a
clearance, the thickness (A) of the
end cap, between the end of the
boom pole and the clamping
piece.
A
Fit the boom pole (1) into the external
clamping piece (2). Fit the M10 bolt
through the internal clamping piece (3)
and slide the assembly through the end
of the boom pole. Locate the bolts in the
holes in the boom pole. Fit the M10 nuts onto the bolts and
tighten. Fit the boom end cap into the
end of the boom as shown above.
3
2
1
3
2