Page 12
For technical questions, please call 1-888-866-5797.
Item 62519
SA
FE
TY
OP
ERA
TIO
N
MAI
NT
ENANC
E
SE
TUP
Mounting Plain Ended Blades
Included as an accessory are two Plain End
Blade Adapters. When installed, they enable
the mounting of plain end saw blades (not
included). To install blades of this type:
1. Using a Hex Key, loosen both set screws on
each of the Plain End Blade Adapters.
2. Slide the gap between the two set
screws over each end of the blade.
3. Evenly tighten all set screws. Pull on the
Adapters slightly to make sure they are secure.
4. Remove the old Blade. Pull the Saw
Table Insert (64) out and rotate it 90° to
the position shown in Figure C:.
90°
Workpiece Foot
Saw Table
Insert
Figure C:
5. Loosen the Blade Tension Knob by turning
counterclockwise about two full turns.
6. Place the Blade Adapter’s bar under the end of
the Lower Blade Holder (45). Make sure that
the blade’s teeth point in the right direction.
7. Push down slightly on the Upper Rocker Arm (15),
and place the other Blade Adapter’s bar over
the end of the Upper Blade Holder (31).
8. Tighten the Blade Tension Knob by turning
clockwise about two full turns.
