10
10
SCENIC W504 User Manual
Eng
1st Unit
5th Unit
4th Unit
3rd Unit
2nd Unit
Power Input
100-240Vac - 50/60Hz
4) DMX Input/Output Sockets
DMX Input is a 3-pin male XLR socket for connection to a DMX control device. DMX
output is a3-pin female socket for sending the DMX control signal to other units.
5.2. About Power Connection
y
Always make sure that the voltage of the outlet you are connecting the product
to is within the range stated in paragraph “8 - Specification” on page 15 or
rear panel of the product (AC110V-240V 50/60Hz).
y
Make sure the power cord is not crimped or damaged. Never connect this prod-
uct to a dimmer pack or rheostat.
y
Never disconnect the product from power cord by pulling or tugging on the cord.
y
To avoid electric shock, all fixtures must be connected to circuits with a suitable
ground and circuit breaker.
y
Wire correspondence is as follows:
Cable (EU)
Pin
International
Brown
Live
L
Blue
Neutral
N
Yellow/Green
Earth
Earth must be connected! Always pay attention to safety! Before taking into
operation for the first time, the installation has to be approved by an expert.
5.3. About Dmx Connection
When use a DMX controller, please make sure that there is no interference
sources (e.g. intercom, high frequency radio waves and radiation source).
DMX machines are designed to receive data through a serial Daisy Chain. A Daisy
Chain connection is where the DATA OUT of one fixture connects to the DATA IN of
the next fixture. The order in which the machines are connected is not important
and has no effect on how a controller communicates to each of them. Use an order
