10
10
SCENIC 100W WW-CW User Manual
Eng
y
Make sure the power cord is not crimped or damaged. Never connect this prod-
uct to a dimmer pack or rheostat.
y
Never disconnect the product from power cord by pulling or tugging on the cord.
y
To avoid electric shock, all fixtures must be connected to circuits with a suitable
ground and circuit breaker.
4) Dmx Connection
When use a DMX controller, please make sure that there is no interference
sources (e.g. intercom, high frequency radio waves and radiation source).
DMX IN
DMX OUT
DMX INPUT
- Male 3-pin a XLR socket for connection to a DMX control device
DMX OUTPUT
- Female 3-pin XLR socket for sending the DMX control signal to
another spark machine or other DMX device.
DMX machines are designed to receive data through a serial Daisy Chain. A Daisy
Chain connection is where the DATA OUT of one fixture connects to the DATA IN of
the next fixture. The order in which the machines are connected is not important
and has no effect on how a controller communicates to each of them. Use an order
that provides for the easiest and most direct cabling.
3-Pin XLR
Pin 1: GND
Pin 2: DMX -
Pin 3: DMX +
OUTPUT
INPUT
DMX use of 3-Pin XLR Connectors
DMX Termonator
Unit 1
Unit 2
Last Unit
DMX 512
Connect machines using shielded 2-conductor twisted pair cable with 3-pin XLR
male to female connectors. The shield connection is pin 1, while pin 2 is Data Nega-
tive (S-), and pin 3 is Data positive (S+).
CAUTION: Wires must not come into contact with each other; otherwise the fix
-
