centauro SP 400, Use And Maintenance Manual, Page: 12 / 50

12
13.7. Starting
Check beforehand that the doors are properly closed, the emergency stop button is
not in the auto-detent position and that the telescopic protection of the blade is fully
lowered onto the table block.
In the models equipped with a switch having an electric brake, once the lockable
cover has been raised, press the green start button
O (fig. 13-4).
It is necessary to turn the knob I of the control switch from "O" to "1".
In the event of the power being cut off, to restart it is necessary to repeat the same
steps, whereas if the magnetic cut-out trips due to short-circuiting it will first be
necessary to press the black push-button again.
Whereas, the models with self-braking motors, press the black key
K (fig. 13-5)
located in the rear of machine, or turn the knob of the master switch N (fig. 13-6)
(depending on model),from position "O" to "1": the white indicator light M (fig. 13-7,
13-8) will come on signalling that the machine is ready for operation, turn knob I from
the “O” position to the “1” position. whereas if the machine is equipped with a star-
delta starter, turn the knob
I as far as the first trip ( ); wait for a few seconds for the
flywheels to reach full speed, then pass on to the second trip ( ) (optional).
In the event of the power being cut off, to restart it is necessary to turn the knob I back
onto "O" before repeating the above procedure.
The same procedure must be adopted if the motor overload cutout is tripped, after
resetting using the red button
X (fig.13-5), or the red button inside the box of the
electric panel for star-delta starting (fig.13-6).
13.8. Stopping
Press red button C (fig. 13-8) or turn the knob I to the "0" position (fig. 13-7).The brake
will cause the machine to stop completely in under 10 seconds.
13.9. Emergency stop (when present)
If problems of any kind occur during processing, press directly on the lockable cover
fig.13-7-1 or emergency button
C (fig. 13-9), which will stop all the machine’s
functions completely, while simultaneously activating the wheel braking system.
Caution: the push-button C, when pressed, remains held; to reset conditions of
normal operation, it is necessary to release it by turning it clockwise.
Fig. 13-6 Starting Fig. 13-5 Starting
X K
Fig. 13-7 Arresto
Fig. 13-4 Starting
Fig. 13-8 Stopping
Fig. 13-9 Emergency stop