7
Before starting any work, check the battery charge (Ref. to § 2.7) and recharge if necessary,
following the instructions in the battery charger user manual.
To
replace the battery, remove it by pressing the release button (9) (Ref. to Fig. 1), then insert the
new battery, sliding it into the guides until it locks.
2.1) Head rotation
For ease of operation, the tool head can rotate through 180°, allowing the operator to work in
the most comfortable position (Ref. to Fig. 2).
Do not attempt to rotate the head when the hydraulic circuit is pressurised.
2.2) Setting
Insert the conductor between the blades up to the desired cutting point (Ref. to Fig. 2).
2.3) Blade advancement
Press the operating button (5) (Ref. to Fig. 2) to activate the motor-pump, the ram will gradually
move forward until the blades touch the conductor.
To halt the advancement, release the push-button (06) and the motor will cut out.
Make sure the blade is exactly positioned on the desired cutting point otherwise re-open the
blade following instructions as per § 2.6 and reposition it.
2.4) Cutting
Firmly hold the tool and operate the button (5) to gradually move the lower blade (4) to cut
through the conductor.
When the cut is performed, release the button (5), otherwise after the maximum pressure relief
valve has activated the motor will stop automatically.
2.5) LED Worklights
Whilst the tool is in operation, the work area is illuminated by four high luminosity LED Worklights
that switch off automatically at the end of the cycle.
2.6) Blade retraction
By operating the pressure release button (10), the ram will retract and open the blades.
In the event that the blades become blocked by conductor strands. Carefully remove
the blockage with, if necessary, a few gentle taps of a rubber hammer on the blades, then press
the release button to open the blades.
ENGLISH
Summary of Contents for B-TC500ND-SC
Page 31: ...31...
