Vibration equipment division
11
TR-NC/8 - R
ev
.02/2013
5.
I
nstallation
•
Prepare the machine to fit the fastening devices (holes, brackets, supports, etc.) of each sensor, then install the sensor
separating it from the relative transmitter.
•
Prepare the cable protection devices (sheaths, ducts) on the machine.
•
Position the junction boxes housing the transducers at a distance from the machine that takes into account the total
length of the extension cable connection.
R
emembeR
that
the
length
of
the
connection
between
the
sensoR
and
the
tRansmitteR
should
not
be
changed
,
as
this
would
Result
in
changes
in
instRument
lineaRity
and
calibRation
.
With the machine stationary, make a first adjustment of the mechanical gap to approximately 1.5 mm.
• F
or sensors installed outside the bearing, this adjustment can be made using a thickness gauge
•
For sensors installed inside the bearing support, it is advisable to measure the total depth of the hole using a gauge and
screw in the sensor so that the mechanical gap is approximately 1.5 mm
•
Recommended probe case torque 10 N x m. For the first 10 threads, maximum torque 3 N x m.
Summary of Contents for TR-NC/8
Page 2: ......
Page 4: ...TR NC 8 Rev 02 2013...
Page 14: ...12 TR NC 8 Rev 02 2013...
Page 18: ...16 TR NC 8 Rev 02 2013...
