CELTIPOL CN-140, Technical Manual

Page: 27 / 45

27
CN-140 TECHNICAL MANUAL
03-2021
Translation of the original manual
17. EXTENDED STOP SEQUENCE (OVER ONE MONTH).

Ensure that the stopcock taps on the products on the gun are fully closed.

Connect the transfer pumps to two separate containers, with an approximate amount of
10 litres of solvent in each.

Spray material on the side blocks, opening the stopcock taps in the products on the gun.
The jet should be aimed at an appropriate container until clean solvent comes out of the
side blocks.

Connect the transfer pumps to two separate containers, with an approximate amount of
10 litres of D.O.P. plasticizer.

Re-add the spray until all the solvent has been bled from the system and only the
plasticizer comes out of the side blocks
12 .

Apply a thick layer of Celtipol grease to each side of the front housing of the gun.

Once again, place the side blocks on the front housing of the gun 13 .

Remove the adapters from the transfer pumps from the product tanks. Clean the plug
adapters with solvent and then cover with Celtipol grease.

Clean the large needles in the plug on the material tanks with solvent, cover with
Celtipol grease; reinstall the plugs/caps on the drums when received from the material
supplier.
12
Do not bleed the
D.O.P. plasticizing fluid
from the accumulated
system.
13
Grease should appear on the tip of the mixing
chamber. Excess grease should be spread over the rest
of the gun to help to eliminate any excess accumulated
spray.