Use the three tightening snaps located at the
bottom of each leg to secure the extended legs
in place.
To set up the tripod, spread the legs outward
until they are fully extended. Extend the center
portion of each of the three tripod legs down 6-
8".
Item #31132
Quick Set-up Guide
1
2
3
All three legs should be the same length to
provide a level platform for the telescope.
4
7
Replace threaded bolt to secure the optical
tube to the mount. Attach the nut to the
threaded bolt by turning clockwise and tighten.
Make sure nut falls into recess.
5
Line up hole in mount with the hole on the
underside of the optical tube as shown above.
6
Properly assembled, optical tube should
appear as pictured above.
8
Remove knurled finderscope nuts from the
optical tube.
9
PowerSeeker 50
Your PowerSeeker 50 includes: optical tube w/ lens
shade attached; tripod with center support bracket;
three eyepieces; a 3x barlow lens, star diagonal,
finderscope with bracket; The Sky™ CD software;
documentation including owner’s manual.
Item# 21039
Remove the threaded bolt from the underside
of the telescope tube.
Questions or Problems with Set-up?
CONTACT:
Celestron Technical Support: 310
.
803
.
5955
