Cedima • Technical Documentation • Joint Cutter CF•1020 D • Issue date: 21/09/2021
58
Removing and fitting blade guard
Set-Up
3.
Using the
"
two
SpannErS
"
(17 mm), unscrew the two
"
faStEning
ScrEwS
" of the
"
protEc
-
tivE
covEr
of
thE
cutting
Shaft
"
.
4.
Remove the
"
protEctivE
covEr
of
thE
cutting
Shaft
"
.
!
Make sure that the dirt guard on the V-belt side
cannot
be removed.
That's it!
6.4.2 Fitting blade guard
Carry out the following steps:
The
"
bladE
guard
"
is fit in the reverse order in the same manner as removing, see the
section "Removing blade guard" (Page 57).
That's it!
