Mini-32-NA-TKE
Quick Start Guide
Thank you for purchasing this
CEDES
cegard/Mini
series light curtain for elevator door protection.
This “Quick Start” guide provides basic mounting
and installation information for the light curtain
system. This document does not replace the
installation and operating instructions for the
components included in this kit.
You must consult the installation and operation
instructions relevant to the devices included in
this kit for additional information regarding this
system, including additional warnings, require-
ments and specifications:
•
cegard/Mini-2000-32-NA Installation and
Operation Manual
(PN: 111 239)
Download this document at:
www.cedes.com
.
Important Notes:
•
This light curtain system must only be installed
and commissioned by qualified elevator
installation personnel.
•
Before beginning installation of this light curtain
system, you must be sure that the elevator has
been properly placed “Out of Service” to ensure
that the elevator and related components will
not be allowed to move during the installation.
You must follow all applicable safety protocols,
rules and regulations that apply.
•
Upon completion of the installation and
commissioning of this system, qualified elevator
installation personnel must ensure that the
installation complies with all applicable local,
regional and national regulatory requirements,
and that the operation of the elevator control
system, including this light curtain, perform in
accordance with the application and regulatory
requirements.
System Description:
This light curtain system is designed to be part of
the elevator door protection system. The trans-
mitter (
Tx
) and receiver (
Rx
) form an invisible
field of criss-cross beams that detect the
presence of persons or objects when one or more
of the beams are interrupted. When an
interruption occurs, the output from the light
curtain changes state to indicate that the doors
should be reopened since a person or object is
present in the detection field.
This light curtain kit includes the following items:
Qty
Description
1
cegard/Mini-200-32 Transmitter
1
cegard/Mini-2000-32-NB Receiver
1
cegard/Mini Transmitter Cable, 5m (16 ft)
1
cegard/Mini Receiver Cable, 5m (16 ft)
2
Spacer Profiles (thick plastic profile)
1
Mounting Profile (thin aluminum profile)
2
Vision Shields
1
Mounting Hardware Bag
Mounting of the Edges:
Important Note:
•
Before you begin, ensure that the transmitter
and receiver are mounted at least 2 inches
(50 mm) apart when the door is in the fully
closed position. This allows the criss-cross
beams to remain active at all times.
Failure to
meet this requirement will likely result in
nuisance reopen conditions.
Potential mounting configurations include:
Use the following step-by-step approach to mount
the light curtain system:
1. Mount the spacer or mounting profiles to the
door wing(s) or slam post. Make sure that the
base of the spacer or mounting profile is no
more than
¼
inch (6 mm) from the sill plate
and that the label indicates “Bottom” nearest
to the sill plate.
2. For mounting profiles, use three #6 x 1
¼
self-
drilling Phillips pan head screws to secure the
transmitter / receiver and the mounting profile
to the slam post.
3. For spacer profiles, mount the spacer profile
to the door wing(s) using four #10 x
½
hex
washer Phillips self-drilling screws. Then use
three #6 x 1
¼
self-drilling Phillips pan head
screws to secure the transmitter / receiver to
the spacer profile using the pre-drilled holes.
4. Make sure that the round circles on the
transmitter and receiver face one another.
5. Snap the vision shield on to the spacer profile
or mounting profile. Make sure that the cable
pigtails on both the transmitter and receiver
extend out the top of the vision shield.
±
10
°
Maximum
