ENGLISH
18
POWER ESPRESSO 20 PROFESSIONALE
5.
Place the jug under the steam wand and turn the steam knob completely anticlockwise (at
least 135º).
6.
Press for the machine to dispense 2 cups of water. Then, press again to close the
pump and wait for 5 seconds.
7.
Restart the device and repeat these steps until there is no more water left in the tank (at
least 3 times).
8.
Brew a coffee with tap water up to the MAX mark, without coffee powder, and repeat the
before steps until there is no more water in the tank (at least 3 times).
6. TROUBLESHOOTING
ERROR
CAUSE
SOLUTION
Water comes out from the
jug or from its lid
The jug is not fitted properly
Make sure the centre of
the jug is aligned with the
brewing outlet.
The level of water in the tank
exceeds the MAX mark
The water level in the tank
should be within the MIN and
MAX mark
Water leaks from the bottom
of the device
There is too much water in
the drip tray
Clean the drip tray
The coffee maker is defective Contact the Technical
Support Service of Cecotec
for advice or reparation
Water leaks from the filter
There is coffee powder on
the filter’s edge
Clean the filter edge
01556_Power Espresso 20 Professionale_Manual_DS.indd 18
20/12/18 9:27
