cecotec 02366, Instruction Manual

Page: 41 / 129

AGUAZERO 6400 / 6400 INOX / 6400 DARK
81 80
ENGLISH ENGLISH
The dishes are
not dry
The dry option was not
selected
Select a programme with a dry option
Low rinse aid dose Increase the rinse aid dose
Rust stains on
the tableware
The quality of the
stainless-steel tableware
is not enough
Use only tableware which is dishwasher
safe
High salt level in the
washing water Set the water hardness level according to
the water hardness table
The salt compartment
cap is not correctly
closed
Check the salt compartment cap is correctly
closed
Too much salt spilled in
the dishwasher when
filling it with salt
Use a funnel to fill the salt compartment to
prevent any spilling
Poor earthing of the
electrical installation Seek the advice of a qualified electrician
immediately
There is
detergent left
in the detergent
compartment
The detergent was added
when the detergent
compartment was wet
Make sure the detergent compartment is
dry before using it.
10. AUTOMATIC FAULT WARNING AND PROCEDURE
PROBLEM
CODE
POSSIBLE
FAULT
PROCEDURE
F5
Insufficient
water
Make sure the water inlet tap is open and the water is
flowing
Remove the tap water inlet hose and clean the hose filter
If the error persists, contact the Cecotec Technical Support
Service
F3
Continuous
water inflow
Close the tap and contact the Cecotec Technical Support
Service
F2
Unable to
drain water
The water drain hose and the filters may be blocked
Cancel the programme
If the error persists, contact the Cecotec Technical Support
Service
F8 Heating error Contact the Cecotec Technical Support Service
F1 Overflow
Unplug the machine and close the tap
Contact the Cecotec Technical Support Service
FE
Defective
electronic
board
Contact the Cecotec Technical Support Service
F7 Overheating Contact the Cecotec Technical Support Service
F9
Diverter motor
position fault
Contact the Cecotec Technical Support Service
F6
Defective
heating sensor
Contact the Cecotec Technical Support Service
- It is recommended that the installation is carried out by authorised service personnel to
avoid possible risks.
- The necessary reparations must be carried out by the Cecotec Technical Support Service.
Cecotec shall not be liable for any damage derived from the procedures carried out by
unauthorised persons. If you need to replace any pieces, make sure you only use original
spare parts.
- Improper repairs or the use of non-original spare parts can cause considerable damage
and put the user at significant risk.