CEBORA S.p.A.
36
3.300.189-B
04/03/2016
GB
6
SERVICE FUNCTIONS.
NOTE: The term “program” refers to a “MIG Short“ or “MIG pulsed” synergic curve developed by
Cebora and saved in the firmware, in non-editable form, in a memory area called “program
number”.
The term “Job” refers to a working point developed starting from a synergic curve, among those
provided by Cebora, with some parameters changed by the user and then saved in a memory area
called “Job number”.
NOTE: In
Standard Program mode
,
Pulsed Arc Program mode
and
Manual mode
, if a “program
number” = 0 (zero) is selected from the Robot Terminal, the programs may be called up from the
Control Panel using the knob
N
, when led
AU
is lit. Led
AU
is selectable with the key
E
.
In
Job mode
, if a “Job number” = 0 (zero) is selected from the Robot Terminal, the saved
working points may be called up from the Control Panel using the knob
Q
.
6.1
Calling up a saved program from the Robot Terminal.
From the Robot Terminal select the
Standard Program mode
(Short synergic curves) or
Pulsed Arc
Program mode
(Pulsed synergic curves)
,
and a “program number” other than 0 (zero).
The Control Panel displays the parameters for the selected program; other parameters are available in the
“Second Functions” menù (par. 7).
If the selected “program number” does not correspond to any synergic curve, displays
O
and
P
show
no
Prg.
6.2
Calling up a saved Job from the Robot Terminal.
From the Robot Terminal, select
Job mode
(synergic curves changed by the user)
and a “Job number”
other than 0 (zero).
Display
O
shows
PrG
and display
P
shows the selected “Job number”. After 3 seconds, the Control Panel
displays the parameters for the selected Job; other parameters are available in the “Second Functions”
menù (par. 7).
If the selected “Job number” does not correspond to any existing Job, display
P
flashes and the remaining
signals on the Control Panel are off
.
6.3
Calling up a saved Job from the Control Panel.
From the Robot Terminal, select the
Parameter Selection Internal mode
to make the Control Panel
operative.
Press the
AZ
key.
The led
M
lights (“Job” function). Displays
O
and
P
show, for 3 seconds,
PrG
and the number of the last
Job used or, if none have ever been used, of the last Job saved.
Within 3 seconds, with knob
Q
choose the “Job number” desired, visualized on display
P
.
After 3 seconds, on Control Panel are shown some parameters relative to the Job chosen; other parameters
are available in the “Second Functions” menù (par. 7).
If to the chosen “Job number” does not correspond any existing Job, the indication on display
P
is
blinking, and the remaining signallings on Control Panel are off.
If the message
PrG
and the “Job number” is already missing from displays
O
and
P
, in order to operate a
new Job choice, press shortly once the key
AZ
, and operate the choice with knob
Q
.
In order to exit the “Job” function press shortly the key
AZ
(twice if the message
PrG
and “Job number”
is already missing from displays
O
and
P
); led
M
is off and Control Panel visualizes the parameters of the
program previously recalled.
