The PM-11module is a mono previous with relay output. When the module receive the Audio input signal the output will
be connected activating the relay.
Specially recommended for automatic applications where the audio signal or the voice is important.
It included a potentiometer to adjust the sensitivity and a protection against polarity inversion.
VOX CONTROL
TECHNICAL CHARACTERISTICS.
Voltage.....................................................................................................
9 -15 V. D.C.
Minimum Consumption...........................................................................
2 mA.
Maximum Consumption..........................................................................
60 mA.
Minimum Input Signal..............................................................................
10 mV.
Maximum Input Signal.............................................................................
300 mV.
Output Impedance...................................................................................
560
Input Impedance......................................................................................
1 K
Frequency Margin.....................................................................................
30 - 17 000 Hz.
Protection Against Polarity Inversions.......................................................
Yes.
Sizes..........................................................................................................
75 x 42 x 30
? ?
? ?
POWER SUPPLY.
Verify
OPERATING.
OUTPUT CONNECTION OF THE LOAD.
INSTALLATION.
ELECTRET MICROPHONE CONNECTION.
The PM-11 circuit had to be supplied by a voltage between 9 and 15 V DC., perfectly stabilised to avoid
to damage the module.
Then, we recommended you the FE-2 power supply which has been developed to perfectly answer to the circuit needs.
Connect the positive of the power supply to the positive terminal indicated in the wiring map, then connect also the
negative of the power supply to the negative terminal indicated in the circuit.
that the assembly has been correctly
done.
Connect input signal and input terminal indicated in the General Wiring Map. In the installation, the
distance between the sound source and the PM-11 had to be as short as possible and as maximum 30 cm. More over,
you have to use a low frequency shielded cable. The input signal could be the signal supplied by auxiliaries input as
mixers, desks, etc.. but this last have to be inferior than 300 mV. as maximum level.
Connect input and output with the power supply. Each time the module will receive an audio signal, it will connect the
output, activating the relay which will be connected till it stop to receive signal. If you wish to adjust the sensitivity level,
you have to use the potentiometer indicated in the General Wiring Map.
The output Module (PM-11) is controlled by a relay, allowing any load until 5
A. as maximum consumption. The operating of this mechanism is the same as a switch, opening or closing its terminals
to allow or not to supply the module, with two (2) terminals NA and common. To obtain the reverse operating, you have
to use NC and Common terminals. In the Output connection paragraph, you could appreciate the typical connection for
a devices operating at 12 VDC and to operate at 220 VAC.
You have to use shielded cable for all connections and connect ground to the chassis of the box.
Maintain a correct distance with other modules as power stage, which could dissipate a big heat. Install the module in a
metallic enclosure with a ventilation grille.
If you wish to connect a microphone to the pm-11 module, you have to
use an electret microphone. To obtain a correct operating, you have to proceed
as following. Seeing the drawing, you have to change the position of the 4.7 uF
capacitor to allow its negative sign to coincide with the negative sign present on
the circuit. Then, you have to connect a 4K7 resistor between positive terminal
of the input signal and the positive terminal of the power supply. Do not forget
that the negative terminal of the microphone is the pin connected to this main
part.
1
E L E C T R O N I C C I R C U I T S
OPERATING.
C2
4.7uF
Micro
Power PM-11
4K7
Input
