Model: DTTW572
WATERPROOF THIN TIP THERMOMETER
-40 to +572°F/-40 to +300°C
FOR THIN CUTS OF MEAT AND
GENERAL PURPOSE COOKING
•
NSF
®
Certified
•
4 second response
•
1.5 mm thin tip
•
3.5"/8.9 cm stem
•
Waterproof (IPX7: protected from water up to
3 feet/1 meter for 30 minutes)
•
Field calibration
•
High heat
•
Max/min
•
Data-hold
•
Big digit
•
180° rotating display
•
On/off button
•
Auto-off after 10 minutes
•
Food-safe ABS plastic with BioCote
®
•
304 stainless steel stem
•
Temperature guide on thermometer
•
2-way mounting: pocket clip/hook
•
Two 1.5V IEC LR44 button alkaline batteries (included)
Note:
Remove label from display before initial use.
Clean the thermometer stem before each use.
Note:
In the following instructions, names of the control
buttons are shown in CAPS. Function information that
appears on the display is shown in
BOLD CAPS
.
BATTERY INSTALLATION
Replace batteries when LCD becomes dim.
“
---
” flashes on the display when the batteries need
to be replaced.
1. Power off the unit before installing the batteries.
A malfunction may occur if the power is on when
the batteries are installed. If a malfunction occurs,
restart the device.
2. Using a small Phillips screwdriver, remove the
screw on the back by the pocket clip by turning it
counter clockwise.
Note:
Be careful to use a properly-sized screwdriver as a
screwdriver too large will strip the screwtops.
3. Remove the cover completely.
4. Install two LR44 batteries with positive (+) sides up.
5. Replace the battery cover.
Important: THE WATER RESISTANT FEATURE REQUIRES
MAINTAINING THE RUBBER GASKET EVENLY WITHIN THE
GROOVE.
6. Fasten the screw on the back by turning it
clockwise, being careful not to over-turn.
OPERATING INSTRUCTIONS
A. On/Off
1. Press the POWER button ( ) to turn the
thermometer on.
2. The DTTW572 will automatically turn off after
10 minutes of inactivity.
3. Press the POWER button ( ) again to turn
the thermometer off and conserve battery life.
B. Temperature Scale
To select temperature reading in Fahrenheit
or Celsius:
1. Using a paperclip, press the °F/°C button
on the back to change the scale.
2. The
°F
or
°C
symbol changes on the display.
C. Display Rotation
While the DTTW572 is on, press and hold the
MAX/MIN button to rotate the display orientation
180 degrees.
Note:
Pressing and holding the MAX/MIN
button in the Max or Min mode will clear
the values.
Tel
800 338-5594
Fax
800 879-2364
Web
CDNmeasurement.com
