CC-ISOBUS CCI 50, Operating Instructions Manual

Page: 319 / 359

CCI.Command
– Operation
76
Section Control: manual mode and auto mode
In manual mode, the sections must be switched on or off in implement operation or
manually using the joystick.
The worked area is recorded.
After activation of auto mode, CCI.Command transfers commands for switching
sections on and off to the implement.
For some implements, the Section Control functionality must also first still be
started in implement operation. See the manufacturer's operating instructions for
the procedure.
4.4.10 Change Section Control mode
The change into manual mode and auto mode takes place via the same button
(F4). The system changes according to which mode is currently selected:
Switch Section Control into auto mode
Switch Section Control into manual mode
To change between manual mode and Section Control auto mode, proceed as
follows:
1. Press the "Auto mode" or "Manual mode" button (F6) on the touchscreen .
→ The mode changes and the symbol on the F6 button changes.
Note
This function is only available if implement data is transferred.