Page
32
of
41
11.
PROCEDURE FOR REPLACING TYRES
The C-1800 Accelair 2 uses a replaceable silicone tyre to provide grip to install
the blown fibre. Two sizes are available; one for smaller fibres and one for
larger fibres. When installing a different fibre or through wear it will be
necessary to replace these tyres.
To replace the tyres remove all 6 M3 countersunk screws. The top
half of the wheel and thus the tyre can now be removed.
Slightly stretch a new tyre over the lower half of the wheel.
Replace the top half of the wheel; the tyre may require slight
manipulation to stretch it on to the top wheel half.
Replace the countersunk screws; note that whilst tightening the
screws the operator should feel the tyre being slightly compressed.
ALWAYS ENSURE TYRES ARE REPLACED AS PAIRS OF THE SAME SIZE.
Retaining
Screws
