Page
15
of
41
6.
OPERATING PROCEDURE
IT IS IMPERATIVE THAT ALL PERSONS USING, OPERATING OR
MAINTAINING THIS FIBRE BLOWING MACHINE:
HAVE RECEIVED COMPREHENSIVE TRAINING IN THE USE OF THIS
MACHINE
ARE COMPETENT TO USE IT,
AUTHORISED TO USE IT AND
HAVE READ AND UNDERSTOOD THIS MANUAL
CBS PRODUCTS LTD. CANNOT BE HELD RESPONSIBLE FOR MISUSE OF
THIS EQUIPMENT.
SETTING UP THE TUBE AND FIBRE
To begin an installation first we must connect the tube and fit the fibre
through the machine. A selection of changeable parts are available to suit any
combination of tube and fibre. Please consult sections 8, 9 and 10 for the
procedures to fit these changeable parts and section 17 for a list of available
parts.
Firstly
it
is
beneficial
and
recommended to install a fibre
blowing bead onto the end of the
fibre. Place the bead over the end of
the fibre and use a small set of pliers
to gently crimp it in place. Try to
deform the bead as little as possible
whilst holding it in place.
