RRS-4 Technical Manual 7/20/2011
3.2 CCM Setup Main Screen
Once the user has verified both safety prompts, the CCM Setup screen will appear
(Figure 6). Here, the operator can view and edit all values associated with performing a
racking procedure in CCM mode. This section will detail the navigation and data entry
for RRS-4 operation in CCM mode.
1.
Amps
– Displays the instantaneous running current of the drive motor at any
given time
2.
Max
– Displays the maximum current recorded during the present motor cycle
3.
Mode
– Press to switch between “Normal CCM” and “Manual”
Normal CCM
– After the initial command is given, the drive motor will
run in the direction chosen by the user without interruption until motor
current exceeds a set value for a set amount of time
Manual
– The drive motor will run without interruption until the
command is released
4.
Direction Indicator
– During drive motor operation, the “hand” will rotate in the
direction that the motor is currently rotating in
5.
Reset
– Resets the stored value of “Max” to zero. Can be used to zero the value
before, during, or after motor cycle
6.
Main
– Returns operator to startup screen
7.
Amps/Tmrs
– Navigates to the screen where values are set for both rotational
directions for maximum allowable current and maximum allowable time over
current value.
1.
2.
3.
6.
5.
4.
3.
7.
Figure 7: CCM setup main
