After the connection of all the external devices, plug the jumper cap of 12-24V,
which is shown as follows.
If you use a power adapter, the interface switch needs to be configured, as seen below.
When the machine is initiated, it is recommended to print some small models so as to
test the validity and accuracy of parameters. Make adjustment to parameter according to
print effect until the printing is in good condition.
3
Computer Test Printing
If you use the power adapter,
the switch can be connected
in both holes. If the switch is
not used then use the available
short connection else, the board
will not get energized and will
not work.
