Cavium FastLinQ 45000 Series, User Manual

Page: 70 / 342

5–Adapter Preboot Configuration
Configuring FCoE Boot
43 BC0154501-00 P
9. For Link Up Delay , select a value from 0 to 30 seconds. The delay value
specifies how long a remote boot should wait for the switch to enable the
port, such as when the switch port is using spanning tree protocol loop
detection.
10. For RDMA Protocol Support , select either None , RoCE , iWARP , or
iWARP+RoCE .
11. Press the ESC key ( Back ).
12. When prompted, select Yes to save the changes. Changes take effect after
a system reset.
Configuring FCoE Boot
FCoE general parameters include the following:
 FIP VLAN ID is usually set to 0 , but if the FIP vLAN ID is known beforehand,
you can set the value here. If a non-zero value is used, FIP vLAN discovery
is not performed.
 Fabric Login Retry Count
 Target Login Retry Count options include:
 Connect (1–8) is Enabled or Disabled .
 WWPN (1–8) shows the WWPN in use (all zeros if the target is offline).
A (+) indicates that the specified target is online, while a (-) indicates
that the specified target is offline.
 Boot LUN (1–8) shows the boot LUN (0–255) that is used by the target
array.
To configure the FCoE boot configuration parameters:
1. On the Main Configuration Page, select FCoE Boot Configuration Menu ,
and then select the following as needed:
 FCoE General Parameters ( Figure 5-8 )
 FCoE Target Configuration ( Figure 5-9 )
2. Press ENTER.
3. Choose values for the FCoE General or FCoE Target Configuration
parameters.